PANAMA TREE MARKING GUN

For over 50 years Panama Pump Co. has been manufacturing quality Pressure Type Tree Marking Guns. These Tree Markers are available with the Elliptical tank which uses 2” padded straps to carry the tank and the Cylindrical tank which uses a back pack carrier to carry the tank. Both tanks are manufactured in both stainless and carbon steel. The stainless steel tanks are well suited for the water based tree marking paints. All Tree Markers have a built in air pump to pressurize the tank. The advantage of a pressure type tree marker is that the paint is forced from the nozzle by air pressure instead of having to use the muscles in your fingers and hand to mark trees. This feature greatly reduces the chance of developing Carpal Tunnel Syndrome and it makes spraying cold and thick paint much easier. You could spray over a gallon of paint with just one trigger pull. The Tree Markers are capable of spraying paint over 20 feet which makes marking the tree “just on the other side of the creek” possible and the self cleaning nozzle is cleaned every time the trigger is released.

The tree Markers are available with 3/64” nozzle for general tree marking and a 1/32” nozzle for lettering and when using tree marking ink. A nozzle spray adaptor is also available for painting a band on a tree. The tree makers have wrenches built into the pump handle and hand piece so no wrenches are needed to assemble or disassemble the paint gun for cleaning. All repair parts are readily available and under normal circumstance the tree markers should give many years of trouble free service.

Panama Cylindrical Tree Marker

  • Backpack Carrier
  • Larger Capacity (1.5 gallons)
  • Higher tank pressure
  • Use External air supply
  • Mark Larger tracts of timber

Panama Elliptical Tree Marker

  • 2” Wide Padded straps
  • Lighter weight
  • Cut off valve on tank
  • No wrenches needed
  • Self cleaning nozzle
  • 1 Gallon Capacity

Assembly instructions and parts list.